The groove installation method of thin-wall stainless steel water pipe is very rich. For the water pipe with more than DN80 pipe length, most of them will choose the groove interface mode. Then what are the methods for installing the groove pipe fitting? I’ll give you a brief introduction.
1. During the installation of the trench pipe fitting, prevent the pipe from being damaged by touching sharp objects.
2. Stainless steel pipe and other spare parts must be avoided in the installation of paint and pipe, in order to prevent the surface of pipe adhesion paint, harm the appearance of beauty
3. During the whole process of installation, if there is an emergency to leave, it is necessary to maintain the not closed branch pipe to prevent other impurities from entering. After installation, pressure test cleaning steps must be carried out to prevent other pollution substances in the running memory of the thin-walled stainless steel water pipe.
4. After the installation of the software of the thin-wall stainless steel water pipe trench system, it is necessary to do the pressure detection, but the pressure detection is done at different levels, and it is a little expensive to carry out a single set, which must be carried out after the completion of all the engineering projects.
5. The construction team needs to check the robustness of the pipes, gate valves, gaskets and standard parts after installation. If there are unsuitable parts, it is necessary to replace them with temporary short pipes as soon as possible, gradually inject water from low voltage and deflate air at high altitude, which is also a hydraulic test. After the hydraulic test is up to standard, it is necessary to carry out sound blowing and washing work to ensure the cleaning of the piping system.
